Supplementary Tables.docx (18 kB)

Supplementary Tables: Design and characterization of a 3D-printed staggered herringbone mixer

dataset

posted on 18.05.2021, 08:37 authored by Megan Valentine, Vedika Shenoy, Chelsea Edwards, Matthew Helgeson

Table S1: Herringbone height measurements.

Table S2: Herringbone width measurements.

Table S3: Herringbone angle measurements.

Table S4 – Number of disfigured herringbones in each cycle for devices 1 and 2.

Funding

This work was supported by the MRSEC Program of the National Science Foundation under Award No. DMR 1720256 (IRG-3). The authors acknowledge the use of the Microfluidics Laboratory within the California NanoSystems Institute, supported by the University of California, Santa Barbara and the University of California, Office of the President. We thank David Bothman and Daniel Magnuson for technical assistance with printing. VJS acknowledges support of the MRSEC-sponsored RISE and FLAM programs. CERE also acknowledges support from the Department of Defense (DoD) through the National Defense Science and Engineering Graduate (NDSEG) Fellowship program

History

Usage metrics

Read the peer-reviewed publication

Design and characterization of a 3D-printed staggered herringbone mixer

Categories

Other biological sciences not elsewhere classified

Keywords

3D printing micromixers microfluidics staggered herringbone mixer 3D printer calibration Biological Sciences not elsewhere classified

Licence

CC BY-NC-ND 4.0

Exports