Future Science Group
Browse
Supplementary Methods.docx (26.56 kB)

Supplementary Methods: Design and characterization of a 3D-printed staggered herringbone mixer

Download (26.56 kB)
dataset
posted on 2021-05-18, 08:37 authored by Megan Valentine, Vedika Shenoy, Chelsea Edwards, Matthew Helgeson

Supplementary Methods:

Microfluidic Device Mold Fabrication and Characterization


Funding

This work was supported by the MRSEC Program of the National Science Foundation under Award No. DMR 1720256 (IRG-3). The authors acknowledge the use of the Microfluidics Laboratory within the California NanoSystems Institute, supported by the University of California, Santa Barbara and the University of California, Office of the President. We thank David Bothman and Daniel Magnuson for technical assistance with printing. VJS acknowledges support of the MRSEC-sponsored RISE and FLAM programs. CERE also acknowledges support from the Department of Defense (DoD) through the National Defense Science and Engineering Graduate (NDSEG) Fellowship program

History